Nissan Pathfinder: System Description - Diagnosis System (electric Shift Control Module) ++

CONSULT Function

APPLICABLE ITEM

CONSULT can display each diagnostic item using the diagnostic test modes as follows.

*1: In some vehicles, it is not malfunctioning in case of no display of "CGW Information". In this case, it is not necessary to switch the CGW status.

*2: Displays when performing "Diagnosis (All System)".

CGW INFORMATION

Display the diagnosis mode which a user can perform in Diag Test mode/Open Mode by switching the CGW status form Restricted mode to Diag Test Mode/Open Mode.

For the method of switching CAN Gateway status, Refer to CONSULT Function.

NOTE:

In some vehicles, it is not malfunctioning in case of no display of "CGW Information". In this case, it is not necessary to switch the CGW status.

SELF DIAGNOSTIC RESULTS

Display Item List

Refer to DTC Index.

How to Read DTC

DTC is displayed on “Self Diagnostic results” of CONSULT.

When DTC is currently detected, “CRNT” is displayed. If “PAST” is displayed, it shows a malfunction occurred in the past. The trip number of drive without malfunction of concerned DTC can be confirmed with “IGN counter” inside “FFD”.

How to Erase DTC

NOTE:

If the ignition switch is left ON after repair, turn OFF the ignition switch and wait for 60 seconds or more. Then, turn the ignition ON again. (Engine stop)

1. Touch “SHIFT” of CONSULT.

2. Touch “Self Diagnostic Result”.

3. Touch “Erase”. (DTC memorized in electric shift control module is erased.)

Freeze Frame Data (FFD)

The following vehicle status is recorded when DTC is detected and is displayed on CONSULT.

DATA MONITOR

NOTE:

The following table includes information (items) inapplicable to this Nissan Pathfinder vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.

Precautions ++Front Suspension