Symptoms | Check items | Probable malfunction location | |
---|---|---|---|
Screen is not switched to camera image, when camera switch is pressed and when shift position is shifted to the reverse position. | “AVM” is not displayed on the system selection screen of CONSULT. | Around view monitor control unit power supply circuit | |
Check that the following "DATA MONITOR" items operate normally using CONSULT
|
"CAMERA SWITCH SIGNAL" and "REVERSE SIGNAL" are normal | Around view monitor control unit | |
"CAMERA SWITCH SIGNAL" or "REVERSE SIGNAL" is not normal | CAN communication | ||
Screen is switched when pressing camera switch or shifting selector lever to the reverse position, however, all views are not displayed. | Only superimposing is displayed (only images that AV control unit plots are displayed). | LVDS (between around view monitor control unit and each camera) | |
Superimposing is not displayed. | AV control unit or LVDS (between around view monitor control unit and AV control unit) | ||
The screen is not switched to the rear view image even if the selector is shifted to the reverse position. | The front view is displayed normally. | CAN communication (Reverse signal) | |
|
Check the following "DATA MONITOR" items using CONSULT.
|
NG | LVDS (between front camera and around view monitor control unit) |
OK | Front camera | ||
|
Check the following "DATA MONITOR" items using CONSULT.
|
NG | LVDS (between rear camera and around view monitor control unit) |
OK | Rear camera | ||
|
Check the following "DATA MONITOR" items using CONSULT.
|
NG | LVDS (between side camera LH and around view monitor control unit) |
OK | Side camera LH | ||
Right side of top view image is not displayed. |
Check the following "DATA MONITOR" items using CONSULT.
|
NG | LVDS (between side camera RH and around view monitor control unit) |
OK | Side camera RH |
Symptom | Possible cause | Possible solution |
---|---|---|
No image is displayed. | The brightness is at the lowest setting. | Adjust the brightness of the display. |
The systems in the video mode. | Press “DISC-AUX” to change the mode. | |
The display is turned off. | Press “
![]() |
|
The interior of the Nissan Pathfinder vehicle is 80°C (176°F) or higher. Fail safe turns the display off. | Wait until the interior of the Nissan Pathfinder vehicle has cooled down. | |
Screen not clear. | Contrast setting is not appropriate. | Adjust the contrast of the display. |
No voice guidance is available. Or The volume is too high or too low. | The volume is not set correctly, or it is turned off. | Adjust the volume of voice guidance. |
Voice guidance is not provided for certain streets (roads displayed in gray). | This is not a malfunction. | |
No map is displayed on the screen. | A screen other than map screen is displayed. | Press “MAP”. |
The screen is too dim. The movement is slow. | The temperature in the interior of the Nissan Pathfinder vehicle is low. | Wait until the interior of the vehicle has warmed up. |
Some pixels in the display are darker or brighter than others. | This condition is an inherent characteristic of liquid crystal displays. | This is not a malfunction. |
Some menu items cannot be selected. | Some menu items become unavailable while the Nissan Pathfinder vehicle is driven. | Park the vehicle in a safe location, and then operate the navigation system. |
Nissan Pathfinder Info Center
Email: info@nipathfinder.com
Phone: +1 (800) 123-4567
Address: 123 Pathfinder Blvd, Nashville, TN 37214, USA
Working Hours: Mon–Fri, 9:00 AM – 5:00 PM (EST)